PROBLEM: Controller won't allow entry to SMART and/or no antenna icon on display

CAUSES

SOLUTIONS

System requires installation of SLW Weather Sensor

Install optional SLW Weather Sensor

SLW Weather Sensor not initialized to controller

Initialize SLW Weather Sensor according to instructions in SMART section

Missing required SMART settings

Push and hold down MODE button for a scrolling message indicating needed information.  Enter needed information for time, date and ZIP Code or Latitude.

Battery in SLW Weather Sensor is drained

Replace battery with AAA LiFeS2 DO NOT use alkaline battery. When inserting battery observe polarity.

Communication cable or wireless communication problem

Check cable and connections at controller.  Use SLW battery diagnostics to check for RF problems on wirelss SLW.  See note below.

Defective SLW Weather Sensor

Replace SLW Weather Sensor.  If SmartLine® controller has no communication for 5 days, it will revert to BASIC program settings

Defective SLHUB communication hub

Replace SLHUB communication hub

The SLW Weather Sensor and transceiver HUB have gotten off of the channel sequence.

Remove the SLHUB from the cabinet. Remove the batteries from the SLW Weather Sensor. Press the rain spindle on the top of the SLW Weather Sensor. Replace the SLHUB int othe cabinet and the batteries into the SLW Weather Sensor and resynchronize by pressing rain spindle.