|
Models: |
Models: |
-
Verify the version of SmartLine controller is compatible through the Advanced menu. Only versions 3.10 and higher are compatible.
- Remove the SmartLink Aircard and accessory bag from the box.
- Note the 19 digit Aircard ID number located on the outside of the box and side of the Aircard. You will need this to activate and register your Aircard on the SmartLink Network.
- For models SL-AIRCARD-M1NA and SL-AIRCARDFLOW-M1NA, screw on the included antenna.
- Run the Aircard cable up through the bottom of the SmartLine controller case. You may need to widen an existing hole using a drill or punch out the area indicated on the bottom.
- Plug the cable into the RJ-11 phone jack located inside the controller. Ensure it is plugged in completely.
- Verify all of the cables are out of the way and close the panel door, ensuring it is closed completely.
- The Aircard status LED will flash rapidly green until it cycles through the 4 status positions. This will last approximately 15-30 seconds.
- If you have not yet activated and registered your Aircard, the Aircard status LED will flash green through the first 3 status positions: Panel, Tower, and Signal. It will then flash red indicating activation is required. See Step 2 – Setting up your SmartLink Network Account to activate. You will need the 19-digit ID number.
- If you have activated the Aircard through the SmartLink Network, the Aircard status will be a solid green light once it establishes communication. If, after activation on the SmartLink Network, the status flashes red, please contact the Help Desk.
- Complete the installation by mounting the Aircard using the screws provided in your accessory bag.
- Models SL-AIRCARD-M1NA and SL-AIRCARDFLOW-M1NA should be mounted with the antenna pointing down.
- Models SL-AIRCARD-M1XX and SL-AIRCARDFLOW-M1XX should be mounted with the antenna pointing up.
You are now ready to add the controller to your SmartLink Portfolio