How to Set Omit Times in SmartLink

Learn how to set an Omit Time in SmartLink Network by following the instructions below

Step 1: Log In and Select Your Controller

1. Go to smartlinknetwork.com and enter your login credentials to access your account.
2. On the Site Page, find the search bar and type in and select your Site Name from the search results.
3. Then click on the Controller name
   -OR-
4. Locate the Controller List at the top, then find and click the Controller name.

Step 2: Access Omit Time Settings

1. On the Controller Page, navigate to the Programming section.
2. Click on Omit Days and Times.
3. Check the Omit Times section to see if any omit times are currently set.

Step 3: Set an Omit Time

1. Click Edit Omit Settings.
2. Under the From section, select the time when the omit will start.
3. For example, if a university starts class at 7:00 AM and finishes at 7:00 PM, select these start and stop times accordingly.
4. Note that program start times are in 10-minute increments. The omit time will end one minute before the program starts to avoid conflicts. (7 AM to 6:59 PM)
5. Ensure the correct AM or PM is selected.

Step 4: Save and Send Changes

1. Click Save Changes at the bottom of the page.
2. Verify the omit time is displayed correctly (e.g., 7:00 AM to 6:59 PM).
3. Click the Send button at the top of the page to apply the changes to your controller.
4. The communication process may take a few minutes.
5. A green Successfully Sent banner will appear when the update is complete.

Still Need Help?

If you have any questions, please email us at support@weathermatic.com or call us at 888-484-3776.

Thank you!

https://app.snapcall.io/weathermatic