Learn how to configure Concurrent Programming on your SmartLine irrigation controller using SmartLink Network by following the instructions provided below
Step 1: Log In and Select Your Controller
- Go to smartlinknetwork.com and enter your login credentials to access your account.
- On the Site Page, find the search bar and type in and select your Site Name from the search results.
- Then click on the Controller name
-OR- - Locate the Controller List at the top, then find and click the Controller name.
Step 2: Adjust Concurrent Programming Settings
- From the SmartLink Controller Page, navigate to the Advanced Settings menu underneath Flow.
- Locate the Max Concurrent Programs option.
- Select how many programs (A, B, C, or D) you would like to run concurrently. You can choose up to four programs.
Step 3: Save and Send the changes to your SmartLine Panel
- Click Save at the bottom of Advanced Settings
- At the top of SmartLink, a red Send button will appear. Click that
- Wait a few moments for the changes to send your panel. A green Successfully Sent banner will appear afterwards
- If a Red Failed to Send banner appears, wait 1 minute and try to Send again
Pro Tips for Optimal Performance
- Prioritize Program D: Program D is commonly used for drip zones. Since drip zones have a lower hydraulic impact, they are recommended as a secondary choice for concurrent programming.
- Stagger Start Times: To prevent a high electrical inrush when multiple zones start simultaneously, stagger the start times of your programs.
Still Need Help?
If you have any questions, please email us at support@weathermatic.com or call us at 888-484-3776.
Thank you!
https://app.snapcall.io/weathermatic